![Ender 3] I keep getting this strange under extrusion. It's only on the walls facing the back of the printer, everything else looks fine. How can I solve this? : r/3Dprinting](https://i.redd.it/hqlvl607ek841.jpg "Ender 3] I keep getting this strange under extrusion. It's only on the walls facing the back of the printer, everything else looks fine. How can I solve this? : r/3Dprinting")
Ender 3] I keep getting this strange under extrusion. It's only on the walls facing the back of the printer, everything else looks fine. How can I solve this? : r/3Dprinting
how-to-fix-over-under-extrusion
Under Extrusion on First Lines of New Layer : r/ender3
Ender 3 underextrusion - 3D Printing Stack Exchange
print quality - Ender 3 severe under-extrusion - 3D Printing Stack Exchange
Under extrusion after retraction – Hardware, firmware and software help – Prusa3D Forum
Gaps in Top Layers | Simplify3D Software
Ender 3 V2 under-extrusion fixed due to Extruder Spring : r/ender3v2
Strange under extrusion issue : r/Creality
print quality - Ender 3 severe under-extrusion - 3D Printing Stack Exchange
Underextrusion on outer wall - Improve your 3D prints - UltiMaker Community of 3D Printing Experts
Sudden under extrusion? (Ender 3 pro) : r/ender3
print quality - Ender 3 severe under-extrusion - 3D Printing Stack Exchange
Mid print under extrusion? : r/ender3
Underextrusion on outer wall - Improve your 3D prints - UltiMaker Community of 3D Printing Experts
reprap - Under extrusion towards the end of the print - 3D Printing Stack Exchange
Ender 3 Under Extrusion - Imgur
Ender 3 under extrusion after travel/when printing infill : r/FixMyPrint
Underextrusion at a seam on ender 3. Tried changing retraction from 0 to 6.5 but nothing changed. Also tried 2 different filaments. Any help would be appreciated. : r/FixMyPrint
Ender 3 Extrusion Issues? Check Out This Tinkercad Quick Fix! - YouTube
Bizarre under extrusion only after first layer - Snapmaker 2.0 - Snapmaker: where creation happens
Under extrusion on Ender 3 – PrusaSlicer – Prusa3D Forum
Having a lot of gaps in infill. I think it's under extrusion in the hot end, but I'm not sure. Exact same gcode will work in different Ender 3, so I know
